How To Make An Exploded Oil Canister

Hello comrades, Comissar Alfie here, and I have a small tutorial for you. I'm going to show you how to make this:

                                                                  Into This!

What you need: An empty pepsi can, Plyers, and spray paint(black)

Steo One:Take your pepsi can, and rinse it out thoroughly.

Step Two: Drain out all the water.

Step Three: Remove Ringpull and tap.

Step Four: Proceed to cut up the top with plyers, Bear in mind it will take a while to cut through the rim, as it is quite thick.

Be careful of the top of the can, as the metal will be quite jagged!!!

Also be careful of the metal shavings, they are VERY sharp!

Step Five: Spray black, give two coats for maximum coverage

And your done!!!

 Now, this dosen't look THAT good, but it's something I did on a day when I was veryb bored, and is something to do with cans of drink. Also the scale is something to be debated over, it would be a very large oil canister for 1/72cnd scale figures. And a small propane tank for 1/35 and 1/32 scale figures, possibly on it's side other than on its top.

I hope you enjoyed this post. Hoora!